First set the road avoidance behavior.
Noise avoidance, road surface avoidance and car avoidance can be
either low or high.
Then set the road characteristics. Roads
can be small or large. Traffic volume can be low or high.
Set the population sensitivity to the four
road effects using percentages. The values entered in the four
boxes must add up to 100% or they will be adjusted automatically.
Click on the Show Road Impact
button.
The result will be displayed as a value
from 1 to 10, where 1 represents the lowest impact on population
persistence.
To run the model again, simply re-set all
parameters and click on the Show Road Impact button.
Pressing the Your Previous
Results button will display the results of all iterations of
the model during one session.
!!! Dieses Dokument stammt aus dem ETH Web-Archiv und wird nicht mehr gepflegt !!!
!!! This document is stored in the ETH Web archive and is no longer maintained !!!